Quelyd Fliseliin is a high-quality adhesive wall covering with non-woven backing. Or heavy non-woven vinyl wallpaper, paintable or not. Can be used in both wet and dry areas.
For wall coverings with a non-woven base
USE
For wall coverings with a non-woven textile base
For vinyl with non-woven textile backing
For wallpapers with a non-woven textile base
TECHNICAL CHARACTERISTICS
Color
Transparent
Tips
Adhesive based on modified starch
Paste preparation time
About 10 minutes
Resistance to microorganisms
Very good (mold and fungus resistant formula)
Full hardening
About 24-48
Application temperature
from + 10 ° C to + 25 ° C
INSTRUCTIONS FOR USE
SUBSTRATE PREPARATION
· Preparation must be carried out in accordance with construction standards.
· The walls must be intact, smooth, smooth, permanently dry, free of dust, grease, or other contaminants, with normal porosity.
PAINTED SURFACES
· Scrape off the peeling paint and level the surface with a sanding pad.
· Glossy and semi-gloss paint, as well as enameled surfaces, must be sanded to give the substrate porosity. Clean sanding dust.
OLD WALLPAPER AND WALLCOVERINGS
· Remove old wallpaper and glue paint with wallpaper remover. Rinse thoroughly to obtain a perfectly clean substrate.
· Very porous substrates must be primed with diluted wallpaper glue.
· When gluing vinyl wallpaper on a new or old substrate, it is recommended to wash the walls thoroughly and then rinse them with an aqueous solution.
ADHESIVE PREPARATION
· Pour the required amount of clean water into the bucket.
· Quickly mix the water with a stick. Pour the contents of one pack into the water, stirring quickly for about 30 seconds.
· Leave for 10 minutes and stir thoroughly again
Type of wall covering
Coldwater mixture (l)
Coverage (m2)
For wall coverings with a non-woven textile base
5
35
For wallpapers with a non-woven textile base
4.5
30
WALLPAPER REINFORCEMENT
· With a medium tuft roller or glue brush, cover the wall in a thick and even layer slightly wider than the width of the sheet.
· Make sure that the glue is evenly applied to the entire surface to be glued.
· Carefully cover the areas around the slats with a brush.
WALLPAPER PASTING
· Carefully cover the areas around the slats with a brush.
· Use pliers to ensure that the first sheet is perfectly straight.
· After gluing the first sheet, carefully slide the wallpaper until the outer edge is in line with the beginning.
· Glue the next sheets with the edge to the edge of the previous sheet.
· Using a wallpaper brush or plastic spatula, gently push the wallpaper from top to bottom and from center to edge to squeeze out air bubbles and smooth out uneven glue areas.
· Flatten the joints according to the manufacturer's instructions.
· Cut off the excess sheet around the windows and slats with a knife.
· Wipe up splashes immediately with a clean, damp sponge.
· Wait at least 24 hours before painting the wall covering.
· Read the gluing instructions carefully and strictly follow the manufacturer's recommendations.
· Do not start gluing wall coverings from the outer corner /
· This adhesive is not suitable for application with an adhesive tool.
POST - USE CLEANING
Tools can be cleaned with warm water.
CONSUMPTION
1 package = 300 g per approximately 35 m2
PACKAGE
300 g package
STORAGE
· This adhesive is not suitable for application with an adhesive tool.
· It must be protected from water, frost, and adverse weather conditions.
· The torn and opened package must be closed immediately and used first.
· The prepared glue can be stored for more than one week in a closed container, protected from frost.
· The maximum storage period is 12 months, subject to the specified storage conditions.